Order by 11:00 and it rides today's truck · Fresno & Clovis dailyCounter open · 5889 E Clinton AveTeam login
MARCOINDUSTRY SUPPLIES · FRESNO

Hard Surface & Floor Care · updated 2026-09

Strip and wax: the full cycle, and how much product a floor takes

Stripper, neutralizer, finish, restorer — in order, with coverage rates so you can order the right amount for a school or a clinic before the summer season.

Strip-and-finish order for a floor

Finish (20–25% solids)25 gal
Stripper concentrate5 gal
Neutralizer concentrate2 gal
Black stripping pads9

Coverage varies with old-finish build and how you apply. Order finish in 5-gallon pails; round up.

Floor season in the Valley is June and July, when the schools empty out and every VCT floor in the county gets stripped and refinished. The contractors who have done it for years order by the pallet in May. The ones doing it for the first time order twice. This is the arithmetic.

The cycle

Strip: an alkaline stripper dissolves the old finish. Apply with a mop or applicator at the label dilution, let it dwell (5–10 minutes — do not let it dry), agitate with a black stripping pad on a rotary machine, pick up the slurry with a wet vac. Rinse. Coverage is typically 300–500 square feet per mixed gallon depending on how many coats of old finish are on the floor.

Neutralize: stripper leaves the floor alkaline, and finish applied over alkaline residue fails — it powders, it does not bond. A neutralizing rinse at the label dilution, mopped and picked up. Skip this step and you will redo the floor in a month.

Finish: apply thin, even coats with a clean finish mop or a flat applicator, let each coat dry fully (30–45 minutes at Fresno humidity), and apply the next. Most commercial floors take four to six coats; high-traffic corridors take more. Coverage is around 2,000 square feet per gallon per coat for a 20–25% solids finish, so a 10,000 square foot school hallway at five coats is 25 gallons — the calculator above does this.

Maintain: a restorer or spray buff between refinishes, burnished with a burnishing pad, extends the cycle. Daily cleaning with a neutral cleaner — not an all-purpose — because alkaline daily cleaners dull finish.

Solids and what they mean

Finish is sold by solids percentage — 18, 20, 25. Higher solids means more finish left on the floor per coat, so fewer coats for the same build, but it is harder to apply evenly and costs more per gallon. 20% is the workhorse for schools; 25% for the corridors that get burnished daily.

The order list for a typical campus

  • Stripper: 1 gallon concentrate per 1,500–2,500 square feet.
  • Neutralizer: 1 gallon concentrate per 4,000–6,000 square feet.
  • Finish: square feet ÷ 2,000 × coats.
  • Pads: black stripping pads (one per 1,000–1,500 square feet, they load up), white or red for scrubbing, burnishing pads for the maintenance cycle. 17 and 20 inch are the common machine sizes.
  • Finish mops or flat applicators, a wet vac, wet floor signs, and a mop bucket you dedicate to finish and never use for anything else.

The hard-surface aisle has all of it, and the truck delivers by the pallet in May and June.

More from the counter