Restoration & Drying · updated 2026-09
Water damage: the first 24 hours, and how many air movers a room needs
Extraction, air movement, dehumidification, and the rule of thumb for equipment counts that the insurers and the IICRC agree on.
Air movers and dehumidification for one room
About 5 air movers and 29 pints/day of LGR capacity on day one.
Rule of thumb from IICRC S500 for a Class 2 loss: 1 mover per ~14 ft of wet wall + 1 per ~60 sq ft of wet floor; ~1 pint of dehumidifier per 50 cu ft. Adjust for class and materials.
A slab leak in a Fresno house at 6 a.m. is a race: get the standing water out, get air moving across every wet surface, get the moisture out of the air, and document all of it before the drywall and the pad start growing something. The contractors who do this well have a checklist. This is the short version of it, with the equipment math.
Hour one: stop and extract
Stop the water. Then extract everything you can with a truckmount or a portable and a water claw — every gallon you extract is a gallon the dehumidifiers do not have to pull out of the air later, and extraction is ten times faster. Pull the pad if it is saturated; it does not dry in place. Lift the carpet along the walls so air can get under it.
Hours two to twenty-four: air movement and dehumidification
Air movers evaporate moisture off surfaces into the air. Dehumidifiers pull it out of the air. You need both, in balance: too many air movers with too little dehumidification just moves wet air around and can drive moisture into materials that were dry.
The IICRC S500 rule of thumb for air movers: one per 10–16 linear feet of wet wall, plus one per 50–70 square feet of wet floor in an open room, positioned at a 5–45 degree angle to the wall so air travels along the surface. Centrifugal (snail) movers for pushing air under carpet and into cavities; axial for open floor. The calculator above turns room dimensions into a count.
Dehumidifiers: an LGR (low-grain refrigerant) unit is rated in pints per day. The initial-day rule for a Class 2 loss (a whole room, walls wet under two feet) is roughly one pint of capacity per 40–60 cubic feet of room; the S500 has the full table by class. A 12×15 room with 8-foot ceilings is 1,440 cubic feet — one mid-size LGR. A flooded 2,000 square foot floor is four to six.
Document or it did not happen
Moisture readings at marked points on day one, with a pin meter on the drywall and a pinless meter on the floor, and a thermo-hygrometer reading for the room and for the dehumidifier's output. Photograph the equipment placement. Repeat every day until the readings match a dry reference. This is what the adjuster pays against.
Antimicrobial and containment
A botanical or quat antimicrobial on the wet structure once the standing water is out. Containment — poly and zip poles — if the loss is sewage or the house is occupied, to keep the drying chamber small and the rest of the house clean.
The restoration aisle has the air movers, dehumidifiers, meters and containment; and a twenty-unit order in Fresno is a same-morning delivery.